COMPLETELY SOLD OUT AT TRIX ... BUT AVAILABLE THROUGH US WHILE STOCK LASTS!Receiver for all DC locomotives with a current, draw up to 2,000 milliamps (motor 2,000 milliamps, lights 300 milliamps). Suitable for digital locomotives with an NEM 8-pin digital connector. • Can be used universally in Selectrix and DCC formats. • Automatic system and analog recognition. • Same locomotive address in Selectrix and DCC operation. • 7 adjustable maximum speeds. • 4 adjustable motor impulse variations. • Automatic load compensation. • Connections for a light function. • Connections for an auxiliary function. • 4-pin SUSI connector for additional special functions in DCC operation. • Short circuit protection for the motor outputs. • Overload protection for the light outputs. • Overload protection for the auxiliary function outputs. • Programming of additional settings by means of selection of the address "00", example: finer gradation of steps for pulse widths (monitoring variation), direction reversing. In Selectrix Operation: • 31 speed levels. • 111 addresses. • Block operation with simple diodes (1 or 2 stopping areas). • Braking operation with a braking diode. In DCC Operation: • Manual speed level selection 14/28 levels. • Automatic switching to 128 speed levels. • Addresses can be either 7 or 14 bits. • Braking operation with direct current and "broadcast-mode" brake generators Dimensions approximately 24.2 x 15.4 x 3.9 mm / 15/16" x 5/8" x 1/8".