JavaScript seems to be disabled in your browser.
You must have JavaScript enabled in your browser to utilize the functionality of this website.Click here for instructions on enabling javascript in your browser.
COMPLETELY SOLD OUT AT TRIX ... BUT AVAILABLE THROUGH US WHILE STOCK LASTS!Receiver for all DC locomotives with a current, draw up to 2,000 milliamps (motor 2,000 milliamps, lights 300 milliamps). Suitable for digital locomotives with an NEM 8-pin digital connector. • Can be used universally in Selectrix and DCC formats. • Automatic system and analog recognition. • Same locomotive address in Selectrix and DCC operation. • 7 adjustable maximum speeds. • 4 adjustable motor impulse variations. • Automatic load compensation. • Connections for a light function. • Connections for an auxiliary function. • 4-pin SUSI connector for additional special functions in DCC operation. • Short circuit protection for the motor outputs. • Overload protection for the light outputs. • Overload protection for the auxiliary function outputs. • Programming of additional settings by means of selection of the address "00", example: finer gradation of steps for pulse widths (monitoring variation), direction reversing. In Selectrix Operation: • 31 speed levels. • 111 addresses. • Block operation with simple diodes (1 or 2 stopping areas). • Braking operation with a braking diode. In DCC Operation: • Manual speed level selection 14/28 levels. • Automatic switching to 128 speed levels. • Addresses can be either 7 or 14 bits. • Braking operation with direct current and "broadcast-mode" brake generators Dimensions approximately 24.2 x 15.4 x 3.9 mm / 15/16" x 5/8" x 1/8".